1 / 5
DDR4 RAM Stick Case / Storage Box (1 to 4 sticks) — zdjęcie 1
1 / 5

DDR4 RAM Stick Case / Storage Box (1 to 4 sticks)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Slim 3-part case for 1 to 4 desktop DDR4 DIMM sticks.

Ocena
5 / 5
Polubienia
6
Pobrania
35
Wydruki
0
Wyświetlenia
100
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Remix of Small SODIMM RAM stick case by @grappeq, adapted to full-size desktop DDR4 DIMM modules. Same idea as the original: a bottom, a lid and thin spacers between the sticks. Two versions share the same lid and spacer, only the bottom changes.

Versions

  • 2 sticks: bottom + lid + 1 spacer. Closed size 148.75 × 40.25 × 15 mm.

  • 4 sticks: 4-stick bottom + the same lid + 3 spacers. Closed size 148.75 × 40.25 × 24.8 mm.

Compatibility

  • Standard-height desktop DDR4 sticks (UDIMM, 288 pins) without heatspreaders.

  • Sticks with heatspreaders are too tall and too thick for this version.

Printing

  • The files are already oriented: print every part flat, no supports needed.

  • If your profile has automatic supports turned on, turn them off: the slicer may otherwise add a small support inside the engraved text.

  • Designed for PETG. With PrusaSlicer's default profiles (Prusa CORE One / CORE One+ HF0.4, 0.20mm BALANCED, Generic PETG), the 2-stick set takes about 1 h 20 min and 45 g of filament, the 4-stick set about 1 h 55 min and 66 g.

  • Test-printed in PETG on a Prusa Core One+: the sticks and the lid fit as intended.

  • The 4-stick bottom is the same design, only deeper. It has not been test-printed yet: feedback is welcome.

How to use

Stick, spacer, stick (and so on), then press the lid on. The finger notches at both ends let you open it.

Files

  • Bottom: ddr4-dimm-bottom (2 sticks) or ddr4-dimm-bottom-4-sticks

  • Lid and spacer, common to both versions: print 1 spacer for 2 sticks, 3 spacers for 4 sticks

  • A ready-to-print 3MF plate for each version

Updates

  • October 2026: added the 4-stick version. The spacer is now 0.3 mm shorter on each end so it slides in more easily; it fits both versions.

The original design is by @grappeq, shared under CC BY 4.0. Go check out and support the original model.

Tagi