Parcel Shelf Clips & Pivot Brackets (Front & Rear) for Honda FIT 2004–2008
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Direct replacement front pivot clips and rear shelf support brackets for the Honda Fit
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A durable, direct-fit replacement set for the notorious, fragile OEM parcel shelf (cargo cover) pivot clips and mounting brackets on the first-generation Honda Fit model years 2004–2008.
The factory plastic clips degrade under UV radiation and snap easily when loading bulky cargo or removing the rear tray. These parts replicate the factory locking tabs and pivot geometry while adding reinforced cross-sections at high-stress shear points.
Included Files / Geometry
Front Pivot Bracket / Clip: Receives the parcel shelf pins when pivoting open.
Rear Shelf Support / Retainer: Secures the trailing edges and prevents rattling over road bumps.
(Note: If mounting to the opposite side of the cabin, simply use the Mirror feature in your slicer along the X-axis unless using the dedicated L/R STLs provided).
Material Warning: Do NOT Use PLA
Recommended Materials: PETG, ASA, or ABS. (ASA is ideal due to superior UV resistance).
Why not PLA? Cabin temperatures under direct sunlight easily exceed 65 °C (150 °F) in warmer months. PLA will reach its glass transition phase ($T_g$), warp under load, and fail within days.
Print Settings & Slicer Recommendations
Orientation: Lay the brackets flat along their primary load-bearing face. Do not orient the pivot pin or clip teeth perpendicular to the build plate where tensile shear will separate layer lines.
Perimeters / Walls: 4 to 5 perimeters (Essential: functional automotive clips rely entirely on wall count for spring tension and snap-fit toughness).
Infill: 35% – 50% (Gyroid, rectilinear, or cubic).
Layer Height: 0.16 mm – 0.20 mm (for tighter tolerances around the clip snap tabs).
Supports: Minimal / build-plate only depending on your chosen orientation. Use organic/tree supports to keep clip retention grooves clean.
Installation
Clear any fractured remnants of the original OEM clip from the cabin trim panel.
Align the mounting alignment tab into the factory sheet-metal/trim slot.
Push firmly until the retention clip engages with an audible click (or secure with factory hardware depending on your trim variant).