ANVIL Magazine MOLLE Carrier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inspired by Zack Freedman's Transwarp Saya, adapted for Sillybutts' ANVIL Magazines.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Reversible, positive locking, top load-able, low hardware. These simple magazine carriers add tons of dense carrying capacity to your Silly shell loadout.
Magazines slide up into the carrier with ease and are held firmly into place with tension from the bungee and outer tabs.
To remove, rock the magazines away from the MOLLE webbing and pull.
Based on the CAD models, these carriers work all the way down to the 2-shell magazines (Getting the 2-shell mags out may be tricky, but the finger holds on the bottom should work).
The only hardware required for these holders is roughly 710mm of 4mm bungee cord.
Once the bungee cord has been weaved, pull it tight. Either cinch the end with a cordlock (The printed ones I use are these https://www.printables.com/model/299878-cord-lock/files), or tie the ends into a knot to keep tension on the bungee.
Weaving instructions are below:
I've also included single-wide variants of these holders. They take up exactly 1.5 MOLLE units in width. These are really intended for use with the eventual release of ANVIL drum magazine variants. Depending on how these handle with drum magazines, I may releasae a revision for better stability when worn on a chest rig.
Happy printing!