INIU P50 Dual Power Bank Stand – Steam Frame Battery Setup
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact stand for two INIU P50 10,000mAh 45W power banks, with outward-facing displays and a tested P1S profile.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this compact stand to hold two INIU P50 10,000mAh 45W power banks upright for storage and charging. Their rounded bottoms make them awkward to stand on their own, so the pockets support them while keeping the USB ports and battery displays accessible.
I use these power banks with my Steam Frame for additional battery life: one charges while I play using the other, then I swap them when needed. The stand keeps the charging battery and spare together between sessions. It also works as a desk organiser for the same power banks when used with phones or other devices.
The two pockets share a centre wall to keep the footprint small. Place the batteries with their displays facing outward in opposite directions. Rounded corners, a broad base and softened edges give it a clean finish.
This is a passive holder: use your usual charging cables and charger. It has no built-in charging electronics.
Battery compatibility
Designed and physically tested with INIU P50, 10,000mAh, 45W power banks. INIU lists this product family as Carry P50-E1. Check the model and dimensions; other power banks have not been tested.
Measured battery body: 53.38 mm wide × 25.60 mm thick × 83.68 mm tall. Each pocket has a 54.18 × 26.40 mm opening, R8 internal corners and a 30 mm depth. The completed print fits my batteries well.
Manufacturer: https://iniushop.com/products/new-iniu-carry-p50-e1-power-bank-45w-smallest-10000mah
Exact Amazon listing tested: https://www.amazon.com/dp/B0DQD35SQ4
Printing
Bambu P1S with a 0.4 mm nozzle and single-colour PLA. 0.20 mm layers, four walls, 20% gyroid infill, five top and bottom solid layers. Print base-down at 100% scale without supports or a brim. Overall size: 72 × 80 × 34 mm. Included profile estimate: about 1 hour 3 minutes and 41 g of PLA.
The Bambu Studio 3MF includes the tested print settings. Select your own printer and loaded filament before printing; re-slice if you change the profile. The STL is included for other slicers, and the F3D is the editable Fusion design.
My Steam Frame setup
For my Steam Frame setup, I use a chubbycable RotateX USB-C to USB-C cable, black, 3.3 ft, with a 180° rotating connector: https://www.amazon.com/dp/B0GG94N6YP
This cable is optional; the stand does not require a particular cable.
