Netgear GS308EP Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The GS308EP has no mounting holes, so I made a cradle for it.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Cradle for the GS308EP, since the switch has no mounting holes
Screws to the wall and the switch slides in from the top
Lips along the front edges hold it in place
Goes in either way: ports up with the power plug through the slot in the bottom shelf, or flipped with the ports down
Sized off Netgear’s published dimensions (158 x 101 x 27 mm) with about 0.6 mm of clearance per side
Cutout in the back plate to save filament and print time
4 countersunk holes for 4 mm / #8 screws, so the heads sit flush against the switch
Use anchors if you’re going into drywall
PLA or PETG, 3 walls, 20% infill
Print standing on the bottom shelf, no supports needed
Fits on any bed 170 x 110 mm or bigger
A straight barrel plug fits through the slot. A bulky right-angle plug might not.