Customizable Gear Ratio 1:3 Hand-Crank Souvenir (12T/36T) - Untested Design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-gear 1:3 gear ratio souvenir with a hand crank. Untested native Playground design. Recipe and guide included.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution
This is an untested design, not a proven print. Fit, clearances, tolerances and print behaviour have not been checked on a real printer, and nothing here promises that printed parts turn freely. Test a small print first.
A two-gear souvenir showing a 1:3 gear ratio (12T/36T spur gears, module 2, 8 mm wide). Each gear sits on its own shaft in a back plate and plinth, with a red crank pin on the first gear. The crank gear has 12 teeth and the output has 36. The output turns once for every 3 crank turns, with 3 times the torque.
How it turns: gears have a 3.0 mm bore radius on 2.8 mm radius shafts, about 0.2 mm radial clearance, and a thin disc on each shaft end keeps the gear on. Teeth mesh at a centre distance equal to the sum of the tooth counts (module 2). The Playground mesh command has no clearance or backlash setting, so teeth clearance could not be tuned. If teeth bind, increase the centre distance a little.
This is a customizable model. Change the tooth counts and colours in the attached Playground recipe and run it in the TrueGeometry Playground (the attached guide shows how). Full commands and design notes: https://blog.truegeometry.com/0_0_0_0/blogs/post-dd502ac2.html
STL notes: the main file is a full-assembly STL in upright Z-up orientation (140 x 56 x 108 mm, 8438 triangles), extracted from the native Playground scene with no repair and no union. It is a display snapshot, not a print-in-place mechanism. Shafts pass into the back plate as overlapping shells with no socket modelled, the crank pin overlaps the first gear, and the native mesh has 198 zero-area triangles. These are kept as they are, not repaired. No slicer or physical print test was done.
Not a toy for young children (small parts). Built with AI assistance in the TrueGeometry Playground.