1 / 3
Desk Cable Grommet 60 / 80 mm – Flush Rotating Cap, Grip Ribs, No Supports — zdjęcie 1
1 / 3

Desk Cable Grommet 60 / 80 mm – Flush Rotating Cap, Grip Ribs, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two-part desk cable grommet for Ø60/Ø80 holes: flush rotating cap with cable slot, grip ribs, prints without supports.

Ocena
0 / 5
Polubienia
1
Pobrania
9
Wydruki
0
Wyświetlenia
25
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Standard Digital File License

A clean two-part cable grommet for the hole in your desk, worktop or TV cabinet. The ring presses into the hole, the cap sits flush with the flange and rotates, so the cable slot can face any direction.

  • Two sizes: for Ø60 mm holes (flange Ø76 mm) and Ø80 mm holes (flange Ø96 mm). Height 3.4 mm above the desk.

  • Flush rotating cap: the cap sits in a 42° conical seat, level with the flange, and turns freely (0.3 mm clearance). Slot 18 mm (Ø60) / 24 mm (Ø80) wide with a rounded end, fits several USB cables, a laptop charger lead or a power cord. Slot edges are rounded.

  • Stays in place: the sleeve (18 mm deep) has 8 vertical grip ribs, 0.15 mm larger than the hole, with a tapered lead-in. They hold the ring tight and stop it turning when you rotate the cap.

  • Prints without supports: both parts print with their visible face on the plate (smooth top), sleeve and skirt pointing up. Every overhang is 42° or less.

Print settings

  • Orientation: as supplied (flange and cap face down). No supports, no brim.

  • 0.20 mm layer, 3 walls, 15% infill. PLA or PETG.

  • Bambu Lab A1, PLA, 0.20 mm, one set (ring + cap): Ø60 – 44 min / 22.7 g; Ø80 – 57 min / 32.7 g.

  • If the hole is undersized or rough, sand the ribs lightly; if it is loose, add a strip of tape.

Designed from scratch by bezbajzlu.

Tagi