Ender 3 - Z-Axis Stepper Damper Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After installing a BLTouch on my printer, the bed leveling process highlighted its need for a z-axis stepper damper. I…
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 1260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
After installing a BLTouch on my printer, the bed leveling process highlighted its need for a z-axis stepper damper. I searched around, and was not satisfied with anything I found. So, I created a model of my own. The only downside of this, is that it requires a couple screws that are not found in common screw sets.
Updates:
2019-03-26 - Added version that plays well with the Ender 3 Pro
Also, check out these other mods that dramatically reduce the sound of your Ender 3
Enjoy the silence...
Print Settings
Resolution:
0.2
Infill:
30
Notes:
3 x wall thickness
Post-Printing
Required:
- 1 x NEMA 17 Stepper motor damper
- 2 x M3*30mm screws
- 2 x M3*6mm flat head screws
Steps:
- Power down printer
- Remove wires from z-axis stepper
- Remove 4040 aluminum extrusion end cap
- Slide the printed mount onto the end to test the fit
(slide on and off until it doesn't stick) 5. Screw the stepper damper onto the printer mount with 2 x M3*6mm flat head screws 6. Remove the z-axis stepper damper from the printer (discard screws and original mount) 7. Remove 2 of the bottom screws from the stepper
(these should coincide with the empty stepper damper mounting holes) 8. Attach the stepper damper to the stepper motor
(I used a folder over piece of paper to ensure there was a small gap between the motor and the end of the printed mount) 9. Slide the motor all the way onto the 4040 frame
(notice that there is a small gap between the motor and the vertical 2040 frame) 10. Reattach wires and z-axis lead screw adapter and 4040 end cap
Optional:(to ensure no binding)
- Loosen brass adapter that connects z-axis lead screw to x-axis/extruder assembly
- Loosen bolts holding top crossbar to the vertical rail
- Lower x-axis assembly to lowest point by manually turning lead screw
- Tighten screws on brass adapter
- Raise x-axis assembly to highest point by manually turning lead screw
- Tighten bolts on top crossbar
Category: 3D Printer Parts