Walimex videolight mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Introduction The original mount on this Walimex videolight for scuba diving broke.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- GNU General Public License v2.0
Introduction
The original mount on this Walimex videolight for scuba diving broke. It's also made from plastics and had threaded M3 holes for attachment. The threads wore out and the lamp was almost lost on a dive. :-(
This replacement part uses M3 square nuts embedded into the part. Unless you break apart the whole thing it should be at least as stable as the original part, if not more.
The original fixation screw on the side is kept and countered with an M5 nut on the inside.
Print instructions
Category: Sport & Outdoors Print Settings
Rafts: No
Supports: Yes
Resolution: 0.15 mm
Infill: 100 %
Notes:
Small support structures are required for the large flat feature. All holes etc. can be printed without as-is, i.e. use "Supports on build plate only" option and you should be fine.