iPad Air 11" mic / note stand holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
iPad holder with tube clamp
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
iPad Air/Pro 11" portrait stand for musicians. Attaches to a 12-16mm thick tube of mic/note sheet stand with sliding clamp. Swing arm 10.5 cm long with optional 9.9 cm extension.
Printed parts
Part | Count |
|---|---|
iPad holder | 1x |
Base disc | 1x |
Swing arm | 1x |
Swing arm extender | 1x (optional) |
Tube clamp | 1x part A, 1x part B |
M3 nut handle | 1x |
M3 nut handle cap | 1x |
M5 nut handle | 2x (3x with extended arm) |
M5 nut handle cap | 2x (3x with extended arm) |
Equipment necessary
Type | Count | Note |
|---|---|---|
M5x22 hex screws | 2 (3 with extended arm) | between swing arm and disc/clamp |
M5 hex nut | 2 (3 with extended arm) | for screws, placed inside nut handles |
M5 washer | 2 (3 with extended arm) | between printed part and nut handle |
M3x30 hex screw | 1 | for sliding clamp, placed inside nut handle |
M3 heat insert | 1-2 (2 recommended, one for each end) | inside clamp slider (part B) |
3 | in iPad holder to attach disc with M3x6 screws | |
M3 washer | 1 | between nut handle and tube clamp |
M3x6 imbus screw | 3 | to attach disc to holder |
Adding a few drops of super glue inside nut handles before closing with cap is recommended
Recommended settings
PETG/ASA/CF materials
20% infill (gyroid)
3-4 perimeters
0.2mm layer height
except for nut handles & caps - 0.15mm
printed with supports