1 / 10
Pool pump adapter 3in buttress to 1-1/2in NPT SCAD — zdjęcie 1
1 / 10

Pool pump adapter 3in buttress to 1-1/2in NPT SCAD

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter to convert from a pool pump wet end (NPT 11.5tpi) to a pool filter housing (buttress thread 8tpi). SCAD model.

Ocena
0 / 5
Polubienia
2
Pobrania
7
Wydruki
0
Wyświetlenia
34
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I created this adapter to connect my old spare pool pump to my newer pool filter housing.  Modeled it after a similar adapter that came with the pump.

Made with assistance from Gemini, but carefully (painstakingly) specced out and verified by myself for correct geometry and fit.

As rendered it consists of 3 sections:

  1. Threaded NPT:  1-1/2" 11-1/2 TPI

  2. Octagonal center for wrench assist.

  3. Buttress thread: 3" 8 TPI

SCAD Notes:

No external libraries required.  All parameters are defined in the SCAD file so they can be easily re-rendered with different values (eg. different diameters or thread pitches).  Rendering takes about 8 minutes on my raptor lake laptop, so be ready for some lag since SCAD tries to preview as soon as you open.  I just hit F6 to start the full render.  The first line ($fn =120) sets the detail level.  120 is high res for final print.  For prototyping set to 60 or lower for faster rendering.

Print settings:

Although this prints beautifully in PLA for prototyping, PLA is not recommended for the final product.  For UV and chlorine resistance PETG, or ASA would be excellent choices.  Also since this needs to be water tight under pressure, extra perimeters are important.

The 3MF file has recommended print settings (PETG):

  • Perimeter generator: Classic (for more accurate threads)

  • Seam position: Random (for better NPT thread water tightness)

  • Perimeters: 7 (to make the threads solid for highest strength)

  • Bottom layers: 5 (buttress face strength)

  • Fill pattern: Gyroid (strength)

  • Fill density: 25% (strength)

  • Extrusion multiplier: 1.02 (better water tightness)

Note:  My final PETG print I used extrusion multiplier 1.04 and turned the fan speed down.  This was for better layer adhesion, but it caused the buttress threads to warp and curl a bit.  The part still functions.  I tested it on the pool pump/filter for several hours with no issues before closing for the season.

Teflon thread tape will help with water-tightness.

WARNING:  If you follow the instructions above it should make a strong part.  However, be aware that NPT are tapered threads and are designed to fit very tight via wedging action.  If you make a weak part it could snap off and get stuck.  You have been warned.