Stick Delete Mod for Miniloong Pocket 1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Joysticks suck - delete it.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 241
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Remove the magnetic cover from the front of the device.
Pull the top of the joystick off, leaving behind the flat "nub".
Unscrew four small hex screws, two on top, two on bottom and put them somewhere SAFE - they are VERY difficult to find if they get knocked into carpet (also not very magnetic).
The front and back shells of the device come apart rather easily, but are held together with clips. I recommend using a PLASTIC pry tool and starting near the top right corner. Slowly move around the case - it should pop open pretty quickly - jiggling it around helps.
The battery is glued to the back panel, and wired onto the motherboard which is attached to the front panel - you do not need to unplug the battery - just rotate the back case 90 degrees and let it rest.
Remove the two black screws holding the joystick in and PUT THEM SOMEWHERE SAFE!
GENTLY lift up the black flap from the left side upwards using a sharp tool - once it's flipped upwards, you can GENTLY wiggle the ribbon cable out - this will allow you to pull the joystick completely free from the front panel.
Insert the 3D printed stick-delete, and use the two black screws to hold it into place.
Make sure you didn't lose any parts (the shoulder buttons seem to fall out easily), and clip/screw the case back together.
All done! :)