T-Beam 1W Slim Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This case suites the T-BEAM 1W. It doesn't provide waterproofing but provides basic protection of the PCB and a handle
- Ocena
- 4 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 50
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a case for my T-Beam 1W which was more compact and less chunky than the others. While this doesn't provide waterproofing it does provide protection from the PCB and accidentally bumping the power switch. The tolerances were based on a single T-Beam 1W, so they might need adjusting in OpenSCAD.
Printing with supports is recommended due to the counter sunk holes.
The front panel attaches using the screws used to hold the battery compartment in. The rear panel attaches to the fan screw holes. The original fasteners are used so you should not need to purchase or use any other fasteners.