Jayo J1 PC4-M6 PTFE fitting nut and washers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nut and washers for adding a PC4-M6 PTFE tube fitting to the Jayo J1 dryer
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Nut and washers for adding a PC4-M6 PTFE tube fitting to the Jayo J1.
The nut is the same for the top and front, the washers are different thickness.
The plug is optional. If you add two fittings you might want to plug the unused one in order to close the air leak.
Be carefull and don't tighten the nuts too much, because you could end up damaging the dryer box!
Print settings:
I recommend printing these in any type of filament that can handle the heat.
I printed mine in Prusament PC Blend (filament default settings, apart from the plug), 4 perimeters, 20% gyroid infill, 0.40mm nozzle, 0.20 layer height
For the plug you might want to slow down the print speed, to prevent overheating issues while printing the rod.
For me setting "Slow down if layer print time is below" to 20 seconds and "Min print speed" to 10 mm/s worked fine (Prusa Slicer: Filaments->Cooling->Cooling thresholds).