1 / 5
Zyxel PM5100-T1 Wall Mount with Fiber Cable Storage — zdjęcie 1
1 / 5

Zyxel PM5100-T1 Wall Mount with Fiber Cable Storage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall mount for Zyxel PM5100-T1 ONT with internal storage to coil the excess fiber optic patch cord.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wall mount for the Zyxel PM5100-T1 ONT  and similar with an internal compartment to store the excess fiber optic patch cord.

ISP-supplied patch cords are usually much longer than needed when the ONT sits next to the optical termination box. Leaving the slack hanging looks messy and puts the fiber at risk from tight bends or pinching. This base keeps the extra cable coiled inside a closed compartment, with no cutting and no sharp bends. The ONT sits on top within the same footprint.

Features

  • Footprint matched to the PM5100-T1, so the mounted assembly looks like a single unit

  • Internal compartment for coiling the excess patch cord with gentle bends

  • Side opening for cable entry and exit, toward the wall box and the ONT’s SC/APC port

  • Lid secured with 4 screws, easy to reopen to adjust the slack

  • Designed for wall mounting next to the fiber termination box, also works on a desk

Hardware

  • 4×M3 x 20 mm socket for the lid

  • 2x M2.5x16 for attaching the ONT to the box using the native wall mount hole (just slide in after tightening a little, neither too much nor too little, u have to finde the correct distance to make the ont slide in and have some resistance)

  • 4x M3x6x5 Heat insert for the box

  • 2x M2.5x5x3.5 for the lid ( for attaching the ont)

  • Wall mounting: Screw or 3M VHB/Similar

Assembly

  1. Mount the base on the wall near the fiber termination box.

  2. Coil the patch cord loosely inside, routing both ends through the side opening.

  3. Close the lid with the 4 screws.

  4. Place the Zyxel on top and connect the SC/APC connector.

⚠ Fiber note: don’t coil the cable tightly and don’t pinch it when closing the lid. Tight bends increase attenuation and can damage the fiber. If the LOS LED turns on or PON starts blinking after installation, check the coil first.

Tagi