Loxone NFC Code Touch — 10 mm Surface-Mount Spacer Frame

A compact surface-mount spacer for the original mounting plate

This frame adds 10 mm of wall clearance behind the original Loxone NFC Code Touch Tree mounting plate. It provides space for wiring and lets you bring a cable in from any of the four sides.

The original mounting plate and its device-retention features remain in use. This print is a spacer, not a replacement for the Loxone mounting plate or latch mechanism.

Fit-tested with the original mounting frame for the NFC Code Touch Tree Anthracite, part no. 100480. Compatibility with other versions has not been verified.

Geometry

• Overall envelope: 81 × 81 × 10 mm.

• Open centre with integrated screw-bearing pads; no solid back plate.

• Corner slot-centre pattern: 55.4 × 55.4 mm, centred on the frame.

• Four tangential 8 × 4 mm slots. Each slot is constructed from two Ø4 mm ends with 4 mm centre spacing.

• Nominal perimeter rail width: 5.5 mm.

• 8 × 8 mm cable-entry recesses at the midpoint of all four sides, with an arched upper profile.

• Each entry is initially closed by a 0.5 mm breakaway outer skin. Open only the entry you need and deburr it before routing the cable.

• 0.2 mm bed-edge relief on the modelled lower contours.

All dimensions are in millimetres. Import the STL at 100% scale.

Printing

Suggested starting settings, based on the fit-tested PLA print:

• Material: PLA; tested with Prusament Galaxy Black.

• Nozzle: 0.4 mm.

• Layer height: 0.20 mm.

• Perimeters: 2.

• Top / bottom layers: 5 / 3.

• Infill: 15% Grid.

• Nozzle temperature: 230 °C first layer, 225 °C thereafter.

• Bed temperature: 60 °C.

• Orientation: wall-facing side on the build plate.

• Brim / raft: none.

• Supports: automatic generation off in the reference setup.

Use temperatures and speeds appropriate to your filament and printer. Open only the required cable entry; its 0.5 mm skin is designed to be removed.

Assembly

1. Select and open the required cable entry; leave the others closed.

2. Place the printed spacer between the wall and the original mounting plate.

3. Use suitable screws and wall fixings for the mounting plate and substrate, allowing for the additional10 mm stand-off. The printed slots are clearance slots, not threads.

4. Route the cable without trapping it between the contact faces. Check terminal clearance and access to the original retention/release mechanism before clipping the device onto its mounting plate.

5. Choose fastener heads that bear correctly on the original mounting plate. Do not distort the plate or crush the printed pads by overtightening.

Development: measured, constructed, printed, corrected

This model was developed collaboratively by Patrick and Rootkeeper, an AI agent running on Hermes Agent.

• Patrick: defined the requirements, supplied the device datasheet and mounting sketch, measured the original frame's 81 mm outer size, and performed the printing and physical fit checks.

• Rootkeeper (Hermes Agent): constructed the parametric OpenSCAD model, exported the STL, performed digital geometry checks and prepared the technical documentation.
  

The construction follows the same open-frame approach as an earlier Wall Display spacer: a continuous perimeter, integrated screw pads and selectively opened cable entries.

Independent accessory design. Not an official Loxone product and not endorsed by Loxone.