Single Cell 18650 USB Battery Charger and Adapter for 14500 Lithium Cell (AA)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This uses the standard TP4056 lithium charge chip with a micro-USB or USB-C version board. also. a 14500 adapter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This single cell charger uses either micro-USB or USB-C cards (pictured). The boards are nearly identical. You will need two pieces of wire and two Keystone 209 Cell Leaf spring battery contact. I bought mine from eBay five years ago. Contacts and boards can be bought from Amazon. Best to solder the wire onto the board first. The long wire to B- and short wire to B+. Insert the board connector end in first and set board flat. There is a hole inside the board cavity that goes through the plastic to the back. Run the long wire all the way through and the short wire straight down through the bottom. I had two types of wire and they measured 1.4mm and 1.5mm. A 2mm diameter may fit. Solder the wires to the clips and push the clips all the way on the narrow section of plastic. Pull the excess wire back into the board cavity and hot glue the board down into place. Even though the clips are securely in place I did hot glue them also. The cover was then glued in place. The cover is 1mm thick. I used white filament through 0.6mm layer and switched to black to finish. In dim light when charging, a red glow can be seen in the plus. It will turn to blue when charged.
The adapter uses two 3mm screws and two nuts for contacts. Use a 3mm x 6mm screw and nut on the thinner end and tighten. On the other end use a 3mm x 8mm but only put the nout on to the end of the thread and superglue in place. This allows the charger spring to push the screw contact to the battery end.