HEXROT – Hexagonal Plant Pot Feet with Honeycomb Drainage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raise your plant pots by 15 mm with hexagonal honeycomb feet, drainage channels and a small retaining lip.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Give your pots a little breathing room.
HEXROT is a compact hexagonal pot foot with an open honeycomb structure and drainage channels underneath. Use four or five feet, depending on the size of the pot, around a planter’s base to lift it 15 mm above the surface while keeping its drainage holes clear. A small lip, centered on one outer side, helps position each foot against the pot’s lower edge.
Features
Open honeycomb cells with no bottom plate.
Crossing underside channels for water passage beneath the main cells.
Centered retaining lip with rounded corners.
One-piece design: no assembly or additional hardware.
Dimensions per foot
55 mm across parallel sides; approximately 63.5 mm across corners.
15 mm pot lift; 19 mm total height including the lip.
4 mm outer frame and 1.8 mm internal walls.
Retaining lip: 10 mm wide × 4 mm deep × 4 mm high above the bearing surface.
Underside channels: 3 mm wide × 2 mm high.
Printing
Printed and tested by the designer in PETG with a 0.4 mm nozzle and 0.20 mm layer height.
Place the flat underside on the build plate, with the retaining lip pointing upward. No supports required when printed in this orientation. Use the appropriate profile for your printer and filament. MMU is optional: this is a single-color model.
For stronger feet, prioritize increasing the number of perimeters (walls) rather than the infill percentage. Start with 4 perimeters; thin sections may already print solid, so additional perimeters will mainly affect thicker areas.
The visible honeycomb pattern is part of the model, not slicer infill. A moderate infill setting of 15–25% is a suggested starting point for any remaining internal spaces. Check the sliced preview to see where infill is actually used. Strength also depends on material, layer adhesion and print quality.
Placement
Print three to five identical feet per pot, depending on the size of the pot. Space them evenly around the bottom perimeter with the retaining lips facing outward. Rest the pot on the flat upper surfaces and keep its drainage holes unobstructed. All feet should contact the supporting surface securely.
Developed with pots approximately 250 mm and 320 mm in bottom diameter in mind. Check your pot’s base and print one foot first to confirm the fit before making a full set.
Files and validation
STL and model-only 3MF files are provided. The 3MF contains the model geometry without printer-specific settings. The STL was checked in PrusaSlicer as one manifold part.
Credits
Designed by Jontino with AI-assisted CAD development. If you print a set, share a Make with your material, settings and pot size!