Walking Leg Mechanics Type 1 Tip & Lift
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I will be posting 3 different walking Mechanicals. This one is very basic and Lifts and tips the gear box as it walks.…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 390
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I will be posting 3 different walking Mechanicals. This one is very basic and Lifts and tips the gear box as it walks. So if your plan is to make a solar powered walking robot then I would use the LEVEL walking design that I will post. A low cost battery gear box with dual output shafts is used that you buy just about every where on line. a few screws and washers to hold it together and the rest is 3d printed. Since I did not make a body for the walking mechanics I just attached a battery box that has a switch built in "two AA batteries" to the frame.
I have added a NEW motor small gear STL that has the D slot running all the way threw, that way even a gear motor with a longer shaft will let the gear seat full in place.
I just added a body mount STL that you print and glue to the motor frame to give you a ftat surface to screw a body on to if you like.
Print Settings
Printer Brand:
MK3
Printer:
Prusa i3
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20
Notes:
I did use supports on the legs for this model. Here is a YouTube vid of the build and actions. https://youtu.be/Pfw_jybhvHU
Category: Robotics