Ghost Nomad Operator Mask [Modern Warfare 4]

Another Operator Mask, this time the new Ghost Mask from Modern Warfare 4. 

As with most other masks i had to take some creative liberty making it decently printable and not too hard to assemble. Parts and Proportions might be adjusted if the original configuration wasnt working for a normal human head.

Note: Left and Right refers to the direction when wearing the mask. not front view. Screw holes differ so you need to print both sides or mirror manually. You cannot print the same part twice for both sides. 

Tips for printing: 

Upper -> I recommend turning it upside down, not quite 180 degrees but at a slight angle. This should help reduce needed supports by a fair bit

Lower -> Print on the flat chin surface with support for the side pieces and depending on printer, more supports for the sides

Cheek Plates -> These all have a flat side but still need supports. Depending on adhesion add supports or skirt. 

Assembly:

The NVG Mount basically sits on top of the little ledge

Plates are to be fixed with glue and screws. Screws per part are noted in the parts section.

Upper sits on the little added ledge of the lower and needs glue as well

See this for general orientation.

Lastly add desired bands through their cutouts and glue them on the inside. 

Use the three provided band holes to make the mask mountable.