QQ-S Pro part-cooler system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to improve upon my first design, and integrated the spacers for the probe-holder into the design, thereby…
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 2
- Wyświetlenia
- 301
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I wanted to improve upon my first design, and integrated the spacers for the probe-holder into the design, thereby simplifying the installation of the frame greatly.
The ducts are wider, more symmetric around the nozzle, and has a much flatter angle of air-flow (14.4 degrees)
If anybody want to make their own ducts, the profile of the mounting interface is an isosceles trapezoid, 10mm bottom, 8mm top, 8mm height.
The length of the mounting interface should be at least 30mm to cover the fan-slots.
This is still a new design, and I have only tried a few prints with it, but so far it seems to do quite ok. I have printed an overhang-testwith PETG, and it printed decently until 75 degrees, but 80 and 85 was quite ugly, but it did not fail.
My PETG Benchy looks like it turned out great, despite the printer not being properly tuned after replacing the hot-end.
Print Settings
Printer:
FLsun QQ-S Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
23
Filament:
Clas Ohlson PETG
Notes:
Mirror the duct in your slicer to make the left side duct.
Turn off "ensure vertical shell thickness" in your slicer to maximize the quality of the ducts.How I Designed This
Category: 3D Printer Parts