Print-in-place Cable Clip with Hinge - 5 sizes (D14.5 to D60)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Strong re-openable cable clip, mechanical hinge printed in place, soft snap latch. PETG, no supports. 5 sizes.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Strong, re-openable cable clips with a mechanical hinge printed in place and a soft snap latch. PETG, no supports, 5 sizes.
STATUS: not yet physically tested. Clearances, collisions and the opening force (about 13 N, a calculated estimate) were checked by calculation and on the 3D models only. Please print the smallest size first and tell me how it goes in the comments.
WHAT IT IS
A clip that bundles cables into a tidy ring and can be opened and closed by hand as many times as you like, with no tools. Unlike a zip tie it is reusable, and you can add or remove a cable without undoing the whole bundle.
WHY THIS VERSION
The original design (a snap ring with a hinge, 2 mm wall) was too weak. This one has a 3 mm wall and 14 mm height, a mechanical hinge (central pin, barrel, 45 degree conical caps so it prints without supports), a softer ball-and-cup latch (0.3 mm interference) so it opens by hand, and an open pose at 90 degrees for printing: print it open, then close it around the cables.
SIZES (inner / outer diameter, mass in PETG)
D14.5: 14.5 / 20.5 mm, about 3.5 g, 4 cables of 6 mm (2x2)
D25: 25 / 31 mm, about 5.2 g, thick bundle, small hose
D40: 40 / 48 mm, about 10 g, conduit, large bundle
D50: 50 / 59 mm, about 14 g, large hose
D60: 60 / 70 mm, about 18 g, very large bundle
Choose an inner diameter equal to your bundle diameter plus 1 to 2 mm.
PRINT SETTINGS
PETG, 0.2 mm layers, no supports, 4+ walls, 40% infill or more, moderate cooling. Print the clip_dXX_ouvert90.stl files as they are. After printing, move the hinge a few times to free it. If the latch is too stiff or releases, adjust the ball interference in the source; for the large sizes a 3.5 mm wall stiffens the ring.
LIMITS
Made to organize cables, not to carry a load. Avoid continuous heat above 60 C.
Parametric source (Python, any inner diameter): https://github.com/pierrre2db/cable-clips-pet-g
Copyright 2026 De Dobbeleer Pierre, CC BY-SA 4.0.
