REMIX* desk clamp drawing tablet holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of desk clamp for drawing tablet MUCH stronger no more deformation of the lower arm that holds the screw
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial
The Clamping area of the original design was pretty nice but I'm able to leave it clamped and not have to move it for long periods of time. Well with PLA that causes stress and deformation of the part specifically where the thread insert goes into the lower armature.
This model version will only accept a 25mm thick desk MAX, uses the same thread insert etc. To Fix the weak spot when left for a long time under pressure i added a simple gusset “wedge” on the bottom arm and a support between the top clamp arm and the slope
Printed with PLA+ and the following settings
.20 layer height 4 walls 5 top/bottom 25% 3d hexagon infill and bolts printed horizontally with “normal” supports “when printing .2 or .12 you dont need support anywhere but the screw and maybe small supports in the through hole on the clamp”