1 / 3
Under-Shelf Mug Hook – Tool-Free Clip-On, 16/18/22 mm Shelf — zdjęcie 1
1 / 3

Under-Shelf Mug Hook – Tool-Free Clip-On, 16/18/22 mm Shelf

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One-piece clip-on hook for a shelf edge: hang a mug by its handle, no screws. 16, 18 and 22 mm boards.

Ocena
0 / 5
Polubienia
4
Pobrania
17
Wydruki
0
Wyświetlenia
50
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

A solid one-piece hook that clips onto the front edge of a shelf and holds a mug under it by the handle. No screws, no glue, nothing to drill - slide it on and it grips.

  • Three shelf thicknesses: 16, 18 and 22 mm boards (clip opening 16.25 / 18.25 / 22.25 mm). Clip arms 30 mm (top) and 34 mm (bottom) deep, 16 mm wide.

  • Grips without screws: a small 0.6 mm bump on the upper arm presses on the board so the hook does not slide off when you take a mug down.

  • Mug hook: 32 mm deep pocket, 16 mm gap - fits the handle of a standard mug (up to about 14 mm thick). The handle rests on the flat bottom of the hook, so the mug hangs straight.

  • Solid and clean: one profile extruded 16 mm, rounded corners, no thin parts. The load goes along the layers, not across them.

  • Prints without supports: it prints lying on its side, every wall is vertical, no supports and no brim needed.

Print settings

  • Orientation: lying on its side (the flat 16 mm face on the plate). No supports, no brim.

  • 0.20 mm layer, 4 walls, 20% infill. PLA or PETG.

  • Bambu Lab A1, PLA, 0.20 mm: 16 mm shelf - 25 min / 9.4 g; 18 mm - 26 min / 9.5 g; 22 mm - 27 min / 9.7 g.

  • If your board is between sizes, choose the closer one.

Designed from scratch by bezbajzlu.

Tagi