Heaters on indicator light post and back plate for Solidoodle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/8bNnCZW2Cur This is just one of those…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/8bNnCZW2Cur This is just one of those almost useless things. Unless you have a no heat problem, then it will tell if power is getting to heaters or not. Or in my case I just like to watch flashing lights!!!!!
Instructions
I added rear cover to hide LED leads and resistors.I used 4k for red 1k for green ,Red is bed heater and Green is for extruder. Then connected wires to heater plugs be careful to match polarity. I then hot glued back on and glued magnet to base.
Category: 3D Printing