RPG Session Box – Full-Size Dice, Pencils, Eraser & Sharpener
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Everything your character sheet needs, in one pocket-sized chest: a full set of dice, two pencils, an eraser and a sharp
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution
Every party needs someone who keeps the supplies in order. Quartermaster is a small magnetic case that carries a full set of dice, two pencils, an eraser and a sharpener. You open it at the table, everything is where it should be, and when the session ends it snaps shut and goes back in your bag.
Slot | Fits |
|---|---|
8 dice pockets (25 × 26 mm) | A standard 16 mm polyhedral set: D4, D6, D8, D10, D%, D12, D20, plus one spare pocket |
2 pencil grooves | Hexagonal pencils 7–8 mm thick, up to 150 mm long |
Eraser pocket | An eraser up to about 42 × 14 × 8 mm |
Sharpener pocket | A small sharpener without a shavings container, up to about 29 × 18 × 14.5 mm |
Spare compartment (46 × 15 mm) | Tokens, a mini, spare dice |
Why it works
Dice are easy to grab. Every pocket has its own depth, so each die sticks out 2–4 mm. You pick it up with two fingers instead of tipping the box over.
Nothing rattles. The pencils lie in V-shaped grooves, and the inside of the closed lid rests just above them. A scoop in the middle lets you lift them out with one finger.
Small items stay easy to reach. The eraser sits on a raised floor and sticks out of its pocket. The sharpener pocket has notches on both ends so you can pinch it out.
The lid closes without forcing. Any die up to the pocket depth + 6 mm fits under it, e.g. a D20 up to 20.5 mm tall.
Magnets on all four corners, so the lid snaps on either way round.
Size
174 × 106 mm footprint, 26.5 mm tall when closed. It fits in a jacket pocket or slides in next to a rulebook.
Printing
Both parts print in the orientation provided, without supports.
Material: PLA or PETG. PETG is more resistant to heat if the box lives in a car.
Layer height: 0.20 mm. Use 0.15 mm if you want smoother pencil grooves and crisper dice labels.
Perimeters: 2
Top solid layers: 5
Infill: 15%
Filament: about 100 g for the tray and 60 g for the lid.
Print the lid first. It’s the shorter job and shows you right away how the magnets fit.
Magnets
You need eight 6 × 3 mm neodymium magnets. The holes are 6.2 mm across and 3.2 mm deep, so the magnets sit just below the surface.
Glue four magnets into the tray, all with the same side facing up.
Stack a second magnet on each one. It will turn to the matching side on its own.
Put glue into the lid holes and close the box for a few minutes.
Use CA glue for PLA, or two-part epoxy for PETG, which holds it better.