RJC Wall Organizer System — Key Hooks (Narrow + Wide)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keys. Hung. Done. Two sizes of dead-simple key hooks for the RJC Wall Organizer System. No pivots, no gimmicks.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Keys. Hung. Done. Two sizes of dead-simple key hooks for the RJC Wall Organizer System. No pivots, no gimmicks — straight-up hooks that print. Printed and fit-tested so you don't have to.
Sometimes the simple answer is the right one. These are straight L-hooks growing from the plate base — I killed three fancier concepts before landing here, and I'm glad I did. They hold keys, lanyards, a 20V DeWalt Flashlight with 2aH battery and padlocks without complaint, and the tall plate covers the full mount slot so you never see ugly keyhole cutouts above the accessory.
Two sizes, one listing:
Narrow (96×110mm) — 3 hooks, 2 posts. Fits anywhere, including bands shared with other narrow accessories.
Wide (216×110mm) — 6 hooks, 4 posts. The full-width key station.
Both carry the RJC badge up top, both use the same v4.3 click-fit posts, both drop in from the top and slide down 40mm to seat.
A note on width: the narrow (96mm) can't share a band with the mail holder (110mm) — they'd overlap about 7mm. Give your key hooks their own band, or pair the narrow with another ≤96mm accessory. That's the 48mm slot grid doing its job.
Specs:
Narrow: 96×110mm, 3 hooks, 2× v4.3 posts
Wide: 216×110mm, 6 hooks, 4× v4.3 posts
Hook: 10mm wide arm, 14mm tall at plate tapering to 10mm, 12mm upturned tip
Compatibility: mounts to any RJC Wall Organizer band (see the Bands & Mounting Kit listing). Part of the RJC Wall Organizer System.
More accessories coming. New designs are always in the pipeline — your bands are ready for them.
Printing suggestions
Orientation: pre-oriented, print as-is (plate flat on the bed, hooks growing up.
Supports: Tree Supports (Auto) For Posts.
Brim: optional.
Layer height: 0.2mm; 0.28mm is fine for the wide one if you're impatient.
Walls/infill: 3–4 walls (hooks take load), 15–20% infill.
Material
PETG recommended — hooks flex under load and PETG handles it better. PLA works.