2 tsp Measuring Scoop | No Supports

2 tsp Measuring Scoop

I needed a 2 tsp measure for my Benefiber, and that's how I got the idea for this scoop. It turned out to be handy all over the kitchen, so it's made for general use: one level scoop is exactly 2 teaspoons, every time.

Use it for

• Supplements: fiber, collagen, electrolytes and other powders

• Baking and cooking: sugar, salt, spices, baking soda, yeast

• Drinks: loose-leaf tea, instant coffee, cocoa, drink mixes

• Around the house: anything you measure out in 2 tsp portions

Features

• 2 tsp capacity with a deep round cup that scoops cleanly and levels off easily

• "2 tsp" embossed on the handle so you always know which scoop it is

• Long handle reaches the bottom of tubs and canisters

• Hang hole on the end of the handle for a hook or keyring

• Small enough to live inside the container: it sits right on top of the powder with the lid closed (see photos)

• Prints in one piece with no supports

Specs

• Size: 102 x 30 x 21 mm (L x W x H)

• Capacity: 2 tsp (about 10 mL), level scoop

Print settings

The included print profile uses these settings (Bambu Lab X1 Carbon):

• Orientation: as-is, cup opening facing up, flat side on the bed

• Supports: none

• Nozzle: 0.4 mm

• Process: 0.20mm Standard (0.2 mm layers)

• Filament: PLA (printed in eSUN PLA+)

• Walls: 2

• Infill: 15% grid

• Plate: Textured PEI

Files

• 3MF: model file for Bambu Studio (the print profile has the full slicer settings)

• STL: for any other slicer

Tips

• Level off the scoop with the rim of the container or a flat knife for an accurate 2 tsp.

• Hand wash only. Hot water and the dishwasher can warp PLA.

• If you want a food-contact print, use a food-safe filament and a stainless steel nozzle. FDM layer lines can hold residue, so rinse and dry the scoop after use.

Print profile

0.2mm layer, 2 walls, 15% infill

Tested profile for the Bambu Lab X1 Carbon, 0.4 mm nozzle. Prints in one piece, cup opening up, with no supports.

• Process: 0.20mm Standard

• Filament: PLA (printed in eSUN PLA+)

• Walls: 2

• Infill: 15% grid

• Plate: Textured PEI

Any PLA works. Use a food-safe filament if the scoop will touch food.

• Sliced for: Bambu Lab X1 Carbon

• Plates: 1

• Print time: about 26 min

• Filament: PLA #FFF144 (9 g)

• File: the 3MF labeled "print profile" in Model Files

Also on MakerWorld, with one-click print profiles for Bambu Studio: 2 tsp Measuring Scoop | No Supports