1 / 3
Under-Desk Power Strip Holder - Screw-On Cradle, 3 Sizes, No Supports — zdjęcie 1
1 / 3

Under-Desk Power Strip Holder - Screw-On Cradle, 3 Sizes, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Screw-on cradle that holds a power strip under your desk. 3 sizes, 30 mm wide, prints without supports.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Standard Digital File License

A solid one-piece cradle that screws to the underside of a desk and holds a power strip or a charger brick off the floor. Slide the strip in from the front, it rests on the bottom with a small lip in front - no straps, no glue.

  • Three sizes (inner pocket width x height): S 45 x 30 mm, M 51 x 36 mm (standard 5-socket strip), L 59 x 40 mm. Each holder is 30 mm wide - use two per strip, one at each end.

  • Easy install: two 5 mm screw holes in the top plate with 90 degree countersinks (wood screws up to about 4.5 x 20 mm). Access holes in the bottom let a screwdriver reach the screws straight from below - mount the holders first, then slide the strip in.

  • Strip stays put: it leans on the back wall, rests on the floor of the cradle and is held by an 8 mm front lip. About 2 mm of free height lets it slip in horizontally.

  • Solid and clean: one profile extruded 30 mm, rounded corners, 5 mm walls. The load goes along the layers.

  • Prints without supports: it prints standing on its side profile, every wall is vertical. No supports, no brim.

Print settings

  • Orientation: lying on its side (the 30 mm face on the plate). No supports, no brim.

  • 0.20 mm layer, 4 walls, 20% infill. PLA or PETG (PETG if the desk is near a heater).

  • Print two per strip.

  • Bambu Lab A1, PLA, 0.20 mm, one piece: S - 36 min / 14.4 g; M - 38 min / 15.7 g; L - 41 min / 18.0 g.

  • Measure your strip first (width x height of the housing without the cable). If it falls between sizes pick the larger one and add a wrap of tape.

Designed from scratch by bezbajzlu.

Tagi