1 / 3
Skeleton Candy Grabber: Print-in-Place Lazy Tongs with Pumpkin Handles — zdjęcie 1
1 / 3

Skeleton Candy Grabber: Print-in-Place Lazy Tongs with Pumpkin Handles

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Squeeze the two pumpkins and a skeleton arm shoots out and pinches the candy. One print, 10 loose bones, no supports.

Ocena
0 / 5
Polubienia
5
Pobrania
28
Wydruki
0
Wyświetlenia
112
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

A scissor linkage (lazy tongs) made of bones. Squeeze the pumpkin handles together and the bones fold out, extending the reach by about 1.7x while the two skeleton fingers at the tip pinch together. Let go and it springs back by hand.

  • Print-in-place: 10 separate bones, every joint is a pin with a 45 degree head that passes through the bone above it (0.35 mm radial, 0.4 mm vertical clearance).

  • Mechanically sound range 30 to 60 degrees; the bones touch and stop at the ends.

  • Printed flat at 45 degrees: 201 x 113 x 9 mm, fits an A1 (and anything bigger).

  • Lower bones are thin (3.2 mm), upper bones are thick (6.8 mm) with undercut pockets over each joint, so nothing needs support. The only overhangs are 13 short bridges (about 3 mm) over the 0.4 mm gap.

  • PLA recommended. PETG may need larger clearance.

Print settings: Bambu A1, PLA, 0.20 mm layer, 1 piece: 1 h 08 min, 24 g. Entry for Halloween 2026: Make It Move.

Tagi