Thrustmaster TH8S Aero Knob: Flat-Sided Palm Grip with Engraved 7+R Pattern
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Palm-size teardrop knob for the TH8S adapter. Flat grip panels, engraved 1-7 + R pattern on top, no supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed directly on the official "Design piece" from Thrustmaster: the bore is the exact negative of that part (cone at the top, 13.9 mm section, 45 degree step, key-shaped lower bore), so it slips over the TH8S adapter with the same fit as the reference.
Shape: 40 mm teardrop, 60 mm tall, flat 31 mm panels on both sides for thumb and fingers, flat top with the 7+R shift pattern engraved 0.5 mm deep (1 3 5 7 / 2 4 6 R).
Bridging-free: the bore is made of 45 degree cones and chamfers, so it prints open end down without supports (one 0.9 mm bridge in the whole model).
Fit check: digital test against the official adapter STL shows 0.8 mm3 of overlap at the nominal seating height (adapter shoulder at the knob open end), i.e. a 1:1 fit.
Print settings: Bambu A1, PLA, 0.20 mm layer, default 2 walls, 15% infill: 58 min / 23 g. For more durability use Thrustmaster recommendation: 5 perimeters, 15% infill. Based on Thrustmaster files licensed CC BY-NC-SA, so this model is non-commercial and share-alike too.