SKÅDIS Coffee Capsule Dispenser for Nespresso Original - No Supports (SlideLock clips)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gravity dispenser for 12 Nespresso Original capsules on IKEA SKÅDIS, with a window to see what's left. No supports.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A coffee capsule dispenser for the IKEA SKÅDIS pegboard: two columns of six Nespresso Original capsules. Load them at the top, take the bottom one out at the front, and the rest drop down. A tall window in each column shows which flavours are left, and a finger notch in the front step makes the bottom capsule easy to grab.
SLIDELOCK: HOOKS THAT PRINT WITHOUT SUPPORTS
The hooks are two separate SlideLock clips that print lying flat (layers along the hook, the strongest way to print one). The dispenser prints upright, and every opening has a 45-degree pointed top, so nothing needs supports.
• The dispenser rests on the top of each clip, so the clips carry the weight in compression.
• Each clip's leg sits behind a 4.8 mm slit it can't pass through, so the dispenser can't be pulled off the clips.
• A spring finger on each clip clicks into a pocket, so the clips stay put when you lift it off the board.
ASSEMBLY (1 minute)
Push a clip's leg into the window at the bottom of a slot on the back.
2. Slide the clip up until it clicks. Same for the second clip.
3. Hang it on SKÅDIS: hooks into two neighbouring slots of one row (40 mm apart), push in, let it drop. Fill from the top.
PRINTING
• Dispenser upright, clips flat, as in the files. No supports, no brim.
• PLA or PETG, 0.2 mm layers, 3 walls, 15% infill.
• Bambu Studio (H2C, one plate): 3 h 55 min, 142 g. The included 3MF is set up and sliced clean.
CUSTOMIZE (OpenSCAD Customizer)
Capsule diameter and height (so other capsule types fit), capsules per column (3 to 10) and number of columns (2 to 4). Keep slidelock.scad next to the .scad file.
Part of a set of five SlideLock organizers: spice shelf, coffee capsule dispenser, self-watering herb planter, dog walk station and thread rack. The clips are the same for all of them.