SKÅDIS Dog Walk Station - Poop Bag Dispenser, Lead and Key Hooks - No Supports (SlideLock clips)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Poop bag dispenser, lead hooks and key hooks for IKEA SKÅDIS, by the front door. No supports anywhere.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A dog walk station for the IKEA SKÅDIS pegboard by the front door: a poop bag roll dispenser, two hooks for leads or harnesses and three key hooks, with WALKIES and two paw prints on the front.
• Bag dispenser: drop a roll in from the top, feed the first bag through the slot underneath, then pull a bag down and tear it off at the perforation. Fits rolls up to 44 mm across and 74 mm wide (both adjustable).
• Lead hooks: deep enough for a lead's handle loop or a harness.
• Key hooks: three small ones between the lead hooks.
SLIDELOCK: HOOKS THAT PRINT WITHOUT SUPPORTS
The SKÅDIS hooks are two separate SlideLock clips that print lying flat (layers along the hook, the strongest way to print one). The station prints upright: the lead and key hooks leave the plate at 45 degrees, the bag box has a 45-degree underside and the bag slot is cut at 45 degrees, so nothing needs supports.
• The station rests on the top of each clip, so the clips carry the weight in compression.
• Each clip's leg sits behind a 4.8 mm slit it can't pass through, and a spring finger clicks it in place.
ASSEMBLY (1 minute)
Push a clip's leg into the window at the bottom of a slot on the back, slide it up until it clicks. Same for the second clip.
2. Hang it on SKÅDIS: hooks into two slots of one row (80 mm apart), push in, let it drop.
3. Drop in a bag roll and pull the first bag through the slot.
PRINTING
• Station upright on its bottom edge, clips flat, as in the files. No supports, no brim.
• PLA or PETG, 0.2 mm layers, 3 walls, 15% infill. The lettering is sunk 0.8 mm: run a paint pen over it if you'd like it to stand out.
• Bambu Studio (H2C, one plate): 3 h 33 min, 115 g. The included 3MF is set up and sliced clean.
CUSTOMIZE (OpenSCAD Customizer)
Bag roll diameter and width, and the word on the front (your dog's name works too). Keep slidelock.scad next to the .scad file.
Part of a set of five SlideLock organizers: spice shelf, coffee capsule dispenser, self-watering herb planter, dog walk station and thread rack. The clips are the same for all of them.