1 / 4
FlexRack - Adaptive Spring-Finger Tool Rack for Pegboard — zdjęcie 1
1 / 4

FlexRack - Adaptive Spring-Finger Tool Rack for Pegboard

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Four spring-finger pockets that grip handles from 6.6 to 18.6 mm: screwdrivers, brushes, pens, files, hex drivers.

Ocena
0 / 5
Polubienia
4
Pobrania
10
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

FlexRack – Adaptive Spring-Finger Tool Rack for Pegboard

Keep your essential tools organized and easy to grab with FlexRack, a four-pocket pegboard tool holder designed to accommodate tools of different sizes.

Each pocket features its own flexible spring finger. Push a tool straight into a pocket, and the finger flexes out of the way before pressing the tool against the opposite wall to help hold it in place. The built-in pocket floors keep tools upright, while the chamfered openings make inserting and removing tools easier.

Features

  • Four individual tool-holding pockets

  • Flexible spring fingers designed to accommodate different shaft diameters

  • Designed for round tools approximately 6.6–18.6 mm in diameter

  • Suitable for small screwdrivers, tweezers, brushes, pens, files, and hex drivers

  • Built-in floors to help keep tools standing upright

  • Chamfered openings for easier tool insertion

  • No additional hardware required for the holder itself

Printing recommendations

PETG is recommended because it generally handles repeated flexing better than PLA. The stated diameter range is a design target and has not yet been physically tested, so actual grip and flexibility may vary depending on your printer, filament, and print settings.

Pegboard compatibility

Designed for IKEA SKÅDIS-style pegboards with 5 × 15 mm slots and a 5 mm board thickness. The mounting fit has been collision-checked against a digital slot model but has not yet been verified on a physical board.

After test-printing, add your printer, filament, and actual fit results here.

Not affiliated with or endorsed by IKEA.