MKS Area 51

This is my core xy that I have been building for a good chunk of the past 6 months now. Theres a couple of parts that I have in there that haven't been tested fully yet so be on the look out for an update soon. This was my first core xy I have ever built so I hope you like it as much as I do, more even. There is a couple parts modeled after https://www.printables.com/@boothyboothy ,whom is not affiliated with me nor does he endorse me in any way, like the carriage, the xy joiner, hotend cover, and v1 of the stepper motor mounts. Of course I gave them a touch of me which according to his license he allows. I included the klipper firmware for the MKS Robin Nano v1.1 and a config file that I used. I am going to also include my extrusion measurements. The bed I used was from a Tevo Nereus 320x320mm, the Extruder came off a Kobra 2 Neo, and the board also came off of the Tevo Nereus. I used a Raspberry Pi 5 for the klipper side of things, and if you like the case for it from the pics it's on my profile page on here and on Printables. You will need to purchase a couple things like a Raspberry Pi 3.5in Display, the blocks to mount the (2) Z-Steppers, (6) 20 teeth GT2 Gears , a 5m GT2 timing belt, and Corner Bracket T Slot Inside L Shape Joint Angle Hardware Connector with Screws. Ithink that is all but if I can think of anything else I will post updates for everyone. If anyone decides to build and/or design their own core xy just be very patient because if you knew how many times I would be almost done then a part refused to work so I had to go back and re-design a part just to get a little further and it happen again. It went like that so many times I had to step away from it several times for a couple of days each headache. So be determined and be more patient. Also the upper feet and skirt was modeled after Voron style feet and skirt who again is not affiliated with me or endorse me in any way. The parts that I remixed of other designers I really loved so thank you guys for allowing others to use and remix your designs.  the display case came from Screwable case for Raspberry Pi + 3.5" Display + Fan // Klipper // Octoprint
by DaLimster whom is not affiliated with me nor do they endorse me in any way. The case ,without a display, in the other photo I made. Happy Printing! I had to remove the stepper mount v2 to do some more testing on them sorry to those who tried them and failed. The first version that here now work great though.

Category: 3D Printers