1 / 1
Embroidery Hoop Clamp-On Ergonomic Handle (Remix) — zdjęcie 1

Embroidery Hoop Clamp-On Ergonomic Handle (Remix)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ergonomic clamp-on handle for embroidery hoops. Quick, easy print to hold your hoop comfortably by hand.

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

Ergonomic Clamp-On Handle for Embroidery Hoops

This is a standalone handheld remix of Jakub Lattenberg's Embroidery hoop holder.

Instead of mounting to a desk or articulated arm, this version is designed purely as an ergonomic handheld grip. Holding a thin hoop edge for hours can cause hand fatigue or cramps; this handle clamps securely onto the hoop rim, giving you a wider, comfortable grip with contoured palm/finger rests.

⚠ Note: This remix removes the mounting connector. It is no longer compatible with the multifunctional arm—it is meant strictly as a handheld accessory.

🖨 Recommended Print Settings
  • Material: PLA

  • Layer Height: 0.20 mm

  • Perimeters / Walls: 2 for the handle, 3 for the screws

  • Infill: 15%

  • Supports: None needed (prints completely flat on the build plate)

  • Orientation: Place the flat clamping faces flat onto the build plate.

🧵 How to Assemble
  1. Place the two clamp halves on either side of your embroidery hoop rim.

  2. Insert your bolts through the clearance holes on the top plate.

  3. Thread into the mating threaded clamp half and hand-tighten until snug and secure.

Tagi