Sony RMB-170 Camera Control Panel Chassis Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount to place Sony RMB-170 on a panel like a rack blank plate.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
This is mount I created to put three of these controllers on a 5RU blank plate as they were being used for studio and remote camera control with fiber camera adapters from Multidyne.
The mount provides a clean front panel and hides any uneven cuts behind the trim piece. The mount is held to the chassis panel using 4mm screws. Four nuts are embedded in the mount during the printing process. Several mounting lugs are provided on the backside for zip ties to secure cables.
Print the mount face down. After 10mm height has printed (at a 0.2mm layer height that's 50 layers, so pause before starting layer 51), pause the print and insert four 4mm nuts in the hex holes.
To connect the RMB-170 to the mount, use four screws into the tapped holes on the controller.
Two PDF templates are provided. One is for a single mount and one for a triple mount. I used the triple template to take to a laser cutter to make a template out of 1/8" MDF which then provided a guide for cutting into a 5RU blank panel. The holes on the template show locations for the holes to mark the corners of the rectangular cut and holes for the 4mm screws that hold the printed mount to the plate.