Lid for pistachio Bowl

This is a lid for the Pistachio Bowl by @PrintimasPri_5188976. It keeps the pistachios fresh and stops the bowl collecting dust between snacks.

The underside has a groove that fits over the top of every wall. A skirt covers the outside of the rim, and a lip sits inside each compartment. The skirt and lips are angled at 4° to match the flare of the bowl wall, so the gap stays even along the full depth of the groove.

Fit details:

• 0.3 mm gap on each side of each wall

• 6 mm deep groove with bevelled lip ends, so the lid slides on easily

• Rounded inner corners that follow the curves where the divider meets the outer wall

• Two shallow pockets over the raised corner peaks, so the lid sits flat on the whole rim and doesn’t rock

• Small 5 mm lift tab on the back edge

Because the lid follows the divider, it only fits one way round. Line up the tab with the back of the bowl, opposite the shell compartment.

Checked against the original STL with no collisions anywhere. Only tested with the original top part.

Print settings

• Orientation: as supplied, top face on the bed, lips pointing up

• Supports: none

• Layer height: 0.2 mm

• Nozzle: 0.4 mm

• Walls: 3 perimeters for stiff lips

• Infill: 15% is fine. The top plate is 2.4 mm thick, mostly solid top and bottom layers.

• Material: PLA or PETG. Printed in PLA on a Prusa Core One.

• Filament: about 90 to 95 g

If your printer over-extrudes or the fit is too tight, scale X/Y up by 0.2 to 0.3%.

Credits: Original bowl design by PrintimasPrime. This remix only adds the lid.