Trailer tarapulin: additional support / Aufnahmen für zusätzliche Spriegelstangen
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for GRP roof sticks for car trailer/ Aufnahmen für zusätzliche GfK-Spriegelstangen an PKW-Anhänger
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Open Community License v1.1
Often trailer raincovers have only few supports and rain puts some puddles on the tarpaulin. Its not only annoying getting wet while operating the trailer, its also a additional heavy load and one big reason for faster wear of the fabric.
So I decidet to add some extra supports. I used a 5-mm-glass-fibre-rod from an old pop-up tent and cut it to the right length. Then i designed and printed some clips to install them at the trailer roof.
The holders and rods keep themself in position only by its tight U-shape and a litte compression force. No glue or screws are used. The original metal structure is 20x20 mm.
Now there are only minor puddles left. Most of the water runs down immediatly.
I printed with PETG and standard profile, but other materials should fit as well. Maybe you avoid PLA because of the low melting temperature.
Size is about:
40x24x22 mm (inner part)
40x44x24 mm (outer part)