Fifine AmpliGame SC3 Mixer Stand, 15 Degree Open-Frame Desk Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Open-frame 15 degree desk riser for the Fifine AmpliGame SC3 mixer. Prints without supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Overview
A desk riser that tilts the Fifine AmpliGame SC3 mixer 15 degrees toward you, so the faders, knobs and mute buttons are easier to reach and read from your chair. The mixer drops into a pocket between two side ledges and rests against a front lip. The back of the stand is fully open, so the XLR, USB-C and line in/out cables plug in and drop straight down behind the desk.
On the Air
I use the SC3 in the shack to monitor rig audio alongside general desk audio: receiver audio into the line input, mixed with PC audio in one pair of headphones, with a hardware fader for each source. Flat on the desk, the SC3's controls sit low and are hard to see past a keyboard or paddle. At 15 degrees you can ride the receiver level by feel while copying, without leaning over the desk.
Print Settings
- Printer: Bambu Lab X1C / X2D, 0.4 mm nozzle
- Material: PETG (PETG-CF also works). PETG is stiffer and less creep-prone than PLA under constant load.
- Layer height: 0.2 mm
- Walls: 4 loops; 3 top and 3 bottom layers
- Infill: 15% gyroid
- Supports: none. Every overhang is 45 degrees or steeper.
- Brim: none. The bottom flange gives enough bed grip.
- Orientation: flat on the bed exactly as modeled, open side up
Hardware and Assembly
No hardware required. Print it, drop the mixer in, plug in your cables.