Nerf Hammershot rear cylinder peg
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A friend managed to lose the peg supporting the cylinder of his Nerf Hammershot, causing occasional misalignments.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 507
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Share Alike
A friend managed to lose the peg supporting the cylinder of his Nerf Hammershot, causing occasional misalignments. This takes care of that.
I modelled it after the original part from my own Hammershot.
Fusion360 File is included. There are two STL files, v1 has the same outer dimensions as the original part, v2 is a little bit smaller. V1 is in use and is really hard to remove and install. V2 is currently untested.
Print instructions
Category: Mechanical Toys Print Settings
Printer: Tevo Tarantula
Rafts: No
Supports: No
Resolution: .2mm
Infill: 20%
Notes:
Printed in PETG, everything not TPE/TPU should work fine.
Post-Printing
If the print has visible layer start/end blobs, remove them.
How I Designed This
I measured the original part with calipers and remodelled it in Fusion360, leaving out the groove in the back, which only serves to reduce material usage, but wouldn't print very well without supports. I'm not even sure the infill would be more material than the additional walls from the groove.