SKADIS Construction Square Holder – T-Clip Remix

Inspired by the SKADIS - Construction Square Holder model created by @Sonark, this remix retains similar dimensions while adapting the design to use the SKADIS T-clip mounting system.

The original design was already a practical solution for organizing construction squares, but I noticed that its mounting system could be adapted to use T-clips.

The rear pegs are designed to print without supports and help prevent unwanted movement when mounted.

A simple modification focused on improving compatibility with my preferred mounting system while keeping the original concept and functionality.

Print Orientation and Parameters

Option 1: Upright

For this option, the model should be printed in the orientation shown in the pictures. Supports are required inside the T-Clip mounting system, while the rear pegs can be printed without supports. However, due to the middle section of the model, this orientation requires more support material overall.

I recommend printing this model in PETG for improved durability and resistance to wear.

Option 2: Flat

For this option, the model can be printed flat on the build plate. Printing in this orientation requires less bridging than Option 1 if supports are not used, so keep your printer's bridging capabilities in mind when choosing this method.

I printed my holder using this option with 4 wall loops and 10% gyroid infill.

An additional mounting lock is included with this version. It fits underneath the mount to help prevent unwanted movement and keep the holder securely attached to the SKADIS pegboard.

Note: Please check the dimensions and fit with your construction square and SKADIS setup before printing.

You can download the original T-Clip model from: