1 / 4
Haunted Tower Zoetrope — zdjęcie 1
1 / 4

Haunted Tower Zoetrope

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An old-school animation toy shaped like a haunted castle tower. Spin it, look through the arrow slits and a bat flaps it

Ocena
0 / 5
Polubienia
4
Pobrania
7
Wydruki
0
Wyświetlenia
53
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Before film there were zoetropes. Inside this tower are 12 pictures of a bat, each one a little further in the wing beat. When the tower spins, the arrow slits work like a shutter: you only see each picture for a moment, so your brain turns them into one flapping bat.

The outside is a little castle tower with battlements, a stone wall, a wooden door and nine raised bats around the top. The tower spins on a printed point bearing, so it keeps turning for a while after one flick.

The bats are cut-outs in flat orange strips, with the black tower wall behind them. The strips print flat and bend into the tower, so no supports and no AMS are needed.

How to use: flick the battlements to spin it, about one turn per second. Look from the side through the slits, with your eyes at slit height. A light above the tower makes the effect stronger.

Size about 12 cm across, 8.5 cm tall, about 125 g of filament. One colour per part: base purple, tower black, two animation strips orange.

Assembly: bend strip A into the tower with the dots at the bottom, do the same with strip B in the other half, then put the tower on the spindle.

Note: designed and checked in CAD (fit and clearances), but not test printed yet.

Tagi