Palette 2 Tube Adapter for Prusa i3MK3/S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my version based on the one by mmontminy here on this site.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 301
- Wydruki
- 3
- Wyświetlenia
- 1309
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
This is my version based on the one by mmontminy here on this site.
https://www.prusaprinters.org/prints/3556-mk25s-mk3s-palette-2-extruder-clip
This version has a similar slide clip system that mmontminy uses but it screws directly to the extruder. The tube is held securely with a quick release clip. The one that comes with the Palette 2S Pro velcro's to the extruder and uses a rubber grommet.
Print instructions
Everything you need is here to tweak and improve at reckless abandon. I included the Fusion 360 model as well if you want to play with it / tweak it. The model timeline and sketches are a little bit of a mess since I had to tweak it a couple times to get the tolerences right to allow the clip to slide easily but not be too sloppy. I'm still new to the level of accuracy that the Prusa can hold on a print. You will need to clean up the clip slots with a hobby knife and I purposely made the filament hole tight to direct it straight into the extruder feed hole. You will need to twirl your hobby knife in it to loosen it to your preferences. If your tubes tapered end is a little long you might need to shave it ever so slightly until the tube notch lines up with the clip slots. Happy Printing!