Fairly OddParents Wand - Functional Light-Up Prop with Electronics
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wand I created for Halloween to go along with a Cosmo and Wanda costume from The Fairly Odd Parents.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
I created this model to go along with my girlfriend and I's Cosmo and Wanda from The Fairly Odd Parents costume for Halloween. Everything can be printed as is, except I would recommend using supports on the stars. I glued everything together with standard hot glue.
Aside from the printed parts, this is what you'll need:
LEDs: 3x Yellow 5mm LEDs
Resistors: 3x 100 Ohm resistors (one for each LED wired in parallel)
Battery: 3.7V Lithium Battery (e.g., 18300 or similar compact cell)
Power Control: Standard momentary/tactile push button switch
Charging Module: USB-C Lithium Battery Charging Board
Wiring: 22-gauge hookup wire
Adhesive: Standard hot glue
I printed the shaft with 100% infill, using black opaque PLA.
I soldered a 3.7v battery, harvested from a disposable vape, to a USB-C charging board which slotted into the bottom cap. I then soldered 22 gauge wire up through the shaft, and connected the positive terminal to a standard button, which I then slotted into the connector piece. The connector piece is meant to hold the 2 halves of the shaft together, and house the button. I secured everything with hot glue. I then soldered 3 LEDs to the positive terminal in parallel with 100 Ohm resistors for each LED, and then soldered each to the negative terminal.
I then printed the star halves using supports, 15% infill, and translucent clear PLA. I would imagine any see through filament would work.
The most difficult part is removing the supports from where the stars slot into the top of the wand shaft, once that's cleaned up, I would recommend connecting one of the stars into the top of the wand shaft, making sure the electronics fit comfortably inside, and then slot the other half, which friction fits both pieces into place, no glue needed.
Then you should have your very own wand prop!
Be careful with the hot glue application as the heat from the hot glue and hot glue gun can warp the PLA, I didn't have too many issues though.
Here is a link to my YouTube video where I show off this project!
