Canyon Flash Rear Light Clip SP0072

Replacement for the small screw-on clip from the mounting kit of the Canyon FLASH rear light, in case you lost it.

The clip is fixed with an M3 countersunk screw into the thread of the seatpost (designed for the Canyon SP0072,

e.g. Grail CF SL/SLX). Slide the light on from above, its tabs engage the side recesses and the tongue snaps over the

light's end wall. To remove, press the tongue down and slide the light up.

Modelled from an original clip and several test prints (dimensions measured on the original).

Printing

- 0.4 mm nozzle, 0.12 mm layers (all heights are tuned to 0.12 mm)

- Material: PETG or ASA recommended. PA6-CF works but is hard to print accurately. No PLA for real use

(brittle, softens in the sun); CF/GF blends are too brittle for the flexing tongue.

- Orientation: lay it on one long side of the block ("lay on face") – the curved back, the catch and the grip teeth

then print without supports. Supports only outside, under the lower pin and the tongue.

- 5–6 walls, 100 % infill, brim recommended

Mounting

- M3 countersunk screw (length to suit the seatpost)

- Tighten gently – the thread in the carbon seatpost is delicate (max. approx. 1 Nm)

- The countersink is intentionally tight; the screw head beds itself in slightly

Note: Not an original part, not made by Canyon. Use at your own risk – check that the light is secure before every ride.