1 / 11
Customizable magnetic Flashforge Creator Pro Leveling Indicator holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this to test the bed leveling of your Flashforge Creator Pro. It is also useful to test the flatness of your bed,…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 373
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (1)Kolekcje (15)Powiązane
Use this to test the bed leveling of your Flashforge Creator Pro. It is also useful to test the flatness of your bed, for example, to detect bubbles after installing a PEI or BuildTak surface.
Features:
- Magnetic
- Customizable, easy to tweak dimensions to the tolerances of your printer.
- Zero indicator insertion force. The indicator is held by two M3 screws rather than applying force fitting it in.
- Uses proper metal threaded inserts.
I built it with these parts:
- Neodymium Cylindrical (1/4 x 1/4) inches Cylinder Magnets. From ebay.
- 2 M3x10 screws.
- Dial indictor, from ebay. I prefer metric over imperial because of the higher sensitivity (1 turn per mm vs 1 turn per 0.1") and 3D is done in metric units anyway.
- M3 thread heat inserts. McMaster http://www.mcmaster.com/#94180A333 . Insert with a hot iron, let the heat do the work, don't push it too hard. You can also buy similar threaded inserts from ebay but you will need to dremel one end to be conic as shown in the picture.
Print Settings
Printer:
Flashforge Creator Pro
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
Material: Hatchbox Orange ABS
Post-Printing
Debarring the hole and long edges using a Shaviv debarring tool.
Category: 3D Printer Accessories