Jenga Storage Case for blocks approximately 75mm x 25mm x 14.7mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2-in-1 storage case and auto-squaring sleeve for Jenga (fits 18-layer, 54-block towers measuring 75x75x265mm).
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
⚠ Quick Note: I struggled to find a box on here that actually fit my Jenga set properly, as block sizes seem to vary. Please double-check your individual block and total tower dimensions below before you hit print! Also: I only printed the 1-piece version on my printer. The 2-part split version has snap-fit joints, but it is untested and you might need a drop of superglue to keep the two halves permanently joined.
Description: Tired of manually lining up your blocks before every game? This is a 2-in-1 storage box and squaring sleeve. Pack your game away securely, and when it's time to play, simply pull the lid off, place the open end flat on the table, and lift the box straight up. It leaves behind a perfectly squared, game-ready tower instantly.
It features a large oval window on the front to easily see the blocks, and a snug friction-fit lid. (The lid is designed to sit safely in the clearance gap just above the tower, so it won't crush the blocks).
Note on the photos: For aesthetic reasons, I used the "fuzzy skin" setting in the slicer (painted onto the outer walls only) to give the box that nice, textured look!
Dimensions & Compatibility:
Block Size: Designed for a standard 18-layer tower (54 blocks) measuring 75mm x 75mm x 265mm. (Individual blocks roughly 75mm x 25mm x 14.7mm)
Box Dimensions: 81mm x 81mm x 271mm tall.
Files Included:
Single-Piece Version: Seamless box for large printers. Requires at least 275mm Z-height (perfect for a Prusa CORE One L).
Two-Part Version: Split in half to fit standard-sized 3D printers. Snaps together (glue recommended).
Universal Lid: Snug fit, works for both versions.
Print Settings:
Supports: None required. The lid prints flat on its top, and the oval window bridges easily without assistance.
Adhesion (Brims): If printing the 2-Part version, the Top half might need a brim to ensure it stays locked to the bed (since it prints upside down). A 5mm brim is also recommended if printing the tall Single-Piece version to prevent corner warping.
Infill: 15% is all you need for structural rigidity.
Aesthetics: Paint "fuzzy skin" on the outside walls in your slicer for the textured finish shown in my pictures.