VTx03 20x20 Stack Tray (M3 & M2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple Eachine VTX03 20x20 stack tray. It holds the VTX03 with a single zip small zip tie, with some room to…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a simple Eachine VTX03 20x20 stack tray. It holds the VTX03 with a single zip small zip tie, with some room to access the button with a small standard screw driver, and a cutout to pass wires through. I made this after trying to print a couple of the options found on here, and they were far too fragile, with far too much needing supports. This prints without supports, and it quite sturdy.
I made it in M3 and M2 flavors. I've printed and used the M3 version, but the M2 version should work the same.
Print it in PLA, PETG, or TPU.
Category: R/C Vehicles