Artillery Sidewinder x1 - Ventilation extension for Yoopai XL enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A ventilation extension for Artillery Sidewinder for Yoopai XL enclosure.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed an extension for the Artillery Sidewinder X1 ventilation system to make it compatible with the Yoopai XL enclosure. The gap between the printer and the enclosure walls is approximately 15cm.
Since the original design by Wazembla (https://www.thingiverse.com/thing:4138965) was too short for my setup, I created these extensions to bridge the gap.
Right Side: This extension mounts to the printer from the inside out. You can secure it using double-sided tape or 3mm screws (requires drilling into the printer frame).
Left Side: This extension mounts from the outside in. If you choose to use screws, you will need to drill holes into the original Wazembla part (left_side_vent.stl).
P.S.: I designed it with tight tolerances to keep hot air away from the printer's cold air intake. You might need to file it down a little bit for a perfect fit.
Enjoy it..